Posts in Category Impedance Measurement

Gated data transfer for increased data sampling rate on the MFIA and MFLI

on 19.12.2018 at 14:42 by Tim Ashworth on Blog of Tim Ashworth
Introduction For measurements of signals which are rapidly changing, for example, when measuring capacitance transients in Deep Level Transient Spectroscopy (DLTS), high temporal resolution is required. In its standard operating configuration, the MFIA (or MFLI with MF-IA option) can sample […]

Square pulses for DLTS measurements on the MFIA

on 22.08.2018 at 16:00 by Tim Ashworth on Blog of Tim Ashworth
Producing square voltage pulses and capturing capacitance transients This blog post shows how to produce square voltage pulses and capture the resulting capacitance transients on a short timescale (20 us) for example, for Deep-level Transient Spectroscopy (DLTS) measurements. Using the LabOne Threshold Unit […]

Rapid and Accurate C-V Measurements on the MFIA

on 19.08.2018 at 15:50 by Tim Ashworth on Blog of Tim Ashworth
Fast C-V measurements up to 3000 V/s This blog post demonstrates the ability of the MFIA (also MFLI with MF-IA option) to measure capacitance on a short timescale (20 us) as a function of DC bias voltage, for example, for […]

Characterization of Dye-Sensitized Solar Cell Impedance at Low Frequencies with HF2IS Impedance Spectroscope

on 03.07.2015 at 12:29 by James Wei on Blog of James Wei
Co-author and main contributor: Dr. Antonio Braga Introduction The electrical impedance spectroscopy (EIS) technique is used to characterize the physical-chemical processes of the dye-sensitized solar cells (DSSC) using different types of metal oxides semiconductors, dyes or electrolytes [1]. The EIS […]

Detecting a small fraction of impedance changes with improved sensitivity

on 16.09.2014 at 13:54 by James Wei on Blog of James Wei
Introduction There are normally two types of impedance measurement. The first type is the dynamic impedance measurement where impedance can change rapidly over time. This is the case in electrical impedance spectroscopy (EIS) in microfluidics for cell counting and cell discrimination […]

Taking Your Microfluidics EIS Measurement to the Ultra-High Frequency Domain

on 08.01.2014 at 13:28 by James Wei on Blog of James Wei
Introduction The HF2IS Impedance Spectroscope from Zurich Instruments is a versatile tool suitable for label-free electrical impedance spectroscopy (EIS) of single cells in the domain of cell counting and discrimination. The high frequency range, from DC to 50 MHz, and the […]

Using HF2IS Impedance Spectroscope for FRA, 2-Terminal and 4-Terminal Measurements

on 19.09.2013 at 14:14 by James Wei on Blog of James Wei
Often there are questions from our HF2IS Impedance Spectroscope users on how to configure the HF2IS for frequency response analysis (FRA), 2-Terminal impedance measurement, or 4-Terminal impedance measurement. This short blog will clarify the proper physical connections as well as […]

Optimize Your Frequency Sweep for Static Impedance Measurement

on 28.02.2013 at 08:20 by James Wei on Blog of James Wei
Very often people want to measure very large static impedance (e.g. small capacitance, large resistance) over a wide frequency range. In the very low frequency region, one may notice that measured curve is not smooth but rather “jiggly”, just like […]

Categories