Posts in Category Tips & Tricks

Fast Frequency Sweeps for Impedance Measurements

on 19.01.2021 at 10:59 by Tim Ashworth
When characterising a device or material as a function of frequency, the resulting spectrum may change with time as the environment or material itself evolves. This time evolution can be captured by taking sequential frequency sweeps with the LabOne Sweeper […]

Compensating Cables for Accurate Impedance Measurements

on 19.01.2021 at 10:45 by Tim Ashworth
Measuring impedance accurately can be a challenge, especially when the device or material under test is located some distance away from the impedance analyzer at the end of cables. The phase delay and parasitic impedance of the cables can significantly […]

Webinar Q&A- Impedance Analysis; Measuring Fast and Low

on 23.06.2020 at 08:01 by Tim Ashworth
This blog post answers the many welcome questions from the audience during the recent webinar “Impedance Analysis; Measuring Fast and Low”. This webinar covered two distinct and equally important impedance measurement challenges. The first involves measuring the low equivalent series […]

DC I-V Sweeps on the MFIA

on 10.01.2020 at 09:07 by Tim Ashworth
Characterizing the impedance of components and materials with the MFIA is done by necessity with an AC signal. However, the MFIA and MFLI can also take DC measurements. This blog post shows how easy it is to take DC measurements, […]

Reloading Data into LabOne Modules

on 29.08.2019 at 12:48 by Tim Ashworth
LabOne now supports reloading data into the LabOne Modules when using the HDF5 file format. Starting from LabOne 19.05, data acquired in modules such as the Sweeper, DAQ, Scope and Spectrum Analyzer, can now be reloaded into the same LabOne […]